YG1 7600 1″ Size, 1-1/2″ LOC, 4 Flute, Bright Solid Carbide Finishing End Mill Seasonal Sale

Little to no coolant required with TiAlN Futura Coating!

Applications

Optimized for finishing operations requiring stability and precision on non-ferrous materials, the YG1 7600 1″ Size, 1-1/2″ Length of Cut, 4 Flute Bright Solid Carbide Finishing End Mill features a rigid 1.5x length-to-diameter ratio. Its 30° helix angle, four-flute geometry, and bright coating ensure smooth chip evacuation and minimize friction, thereby reducing heat buildup and burr formation during profiling and finishing of brass, bronze, and acrylic plastics.
The sharp geometry combined with a polished bright coating decreases grabbing tendencies often seen in free-machining non-ferrous alloys, promoting clean edge finishes and consistent surface quality. While lacking a corner radius requires careful handling to prevent chipping during interrupted cuts, it allows precise contouring without radius-induced deviations. Coated end mills typically perform better on hard steels. Its design closely follows recommended combinations for non-ferrous materials, especially where fine edge finishes and controlled chip flow are essential.

Features

• Possible for high-speed cutting, suitable for high efficiency machining for hardened & high alloy steels, steel casting, chill casting, malleable cast iron, CrNi-steels, brass, copper, aluminum with a high percentage of silicon and abrasive plastics.