YG1 59595 5/8″ Size, 4″ LOC, 5 Flute, Bright Solid Carbide Finishing End Mill Express Delivery

Applications

This solid carbide 5-flute finishing end mill features a 45° high helix angle and center cutting geometry, optimized for clean, precise finishing passes in aluminum, brass, bronze, copper, plastics, and similar materials. The bright finish coating preserves a sharp, polished cutting edge that excels in low-to-moderate speed machining, reducing built-up edge and allowing smooth chip evacuation. Its 5/8″ diameter with a 4″ cut length and single end design provides rigidity and control for detailed contouring and fine surface finishes. Use this tool when consistent precision and a polished finish are required in non-ferrous and softer materials, especially where a sharp uncoated edge is advantageous over coated alternatives.

Features

• Designed to machining stainless steel, inconels and other alloys.
• The new design of stub length allows cutting at maximum speeds and feeds with minimum deflection.
• 5 Flute and 45 degree medium helix allow harmonic balance and smooth cutting.